a quick study of the G&L Legacy, built May 2014, that i discuss in my introduction here http://guitarsbyleo.com/FORUM/viewtopic ... 47&t=11016
rosewood FB, stock electronics, both tone pots at 5
when i brought my new Legacy back to the dealer he concurred that it had not been properly set up at the factory. he said he even had to file the nut slots. so far the action and the intonation are excellent. he also locked down the bridge to the body (ie only downward dives are possible)
1. factory new with 10's:
2. after a little pickup height & saddle adjustment by me (strings:GHS boomer 10.5's):
3. after the proper setup mentioned above (ernie ball 11's)
also, if interested: 4. after realizing the -18dB pad was engaged on my DI, removing the pad (increasing the DI gain) & lowering audio interface input trim -15dB
[ie in #3, the audio interface is acting as 'preamp' and in #4 it's the DI]
recording chain: Radial J48 active DI - Steinberg/Yamaha MR816x - lightpipe to RME9652 - Cubase6 - Amplitube (one of the fender blackface presets)
additional reference- my 2 cheap frankenstrats with SAME electronics (SeyDunc SSL-1's, custom wiring): lower the volume to about 60% for these 2:
#1 lightweight yardsale special
#2 heavier body craigslist special
cheers
what a difference a setup makes
-
- Posts: 15
- Joined: Thu May 22, 2014 1:02 pm
- Location: Providence, RI USA
-
- Posts: 1632
- Joined: Sat Jan 07, 2012 11:46 pm
- Location: Grayslake, IL
Re: what a difference a setup makes
3. sounded best to me, thing really sings