1981 F-100 vibrato questions

[Reverdetoc]

Hi everyone,

I have two questions about the tremolo system on my 1981 F-100:

1. What size Allen key is needed to tighten and loosen the set screw? I had the number at some point, but I seem to have misplaced it. Couldn't easily find it online.

2. Are there any tips/hacks to keep the screw tightened? It seems like every time I tighten it, it'll stay in place if I leave it alone, but after maybe 30 seconds of active handling it loosens up again.

Thank you!

[Craig]

Hi everyone,

I have two questions about the tremolo system on my 1981 F-100:

1. What size Allen key is needed to tighten and loosen the set screw? I had the number at some point, but I seem to have misplaced it. Couldn't easily find it online.

2. Are there any tips/hacks to keep the screw tightened? It seems like every time I tighten it, it'll stay in place if I leave it alone, but after maybe 30 seconds of active handling it loosens up again.

Thank you!

See this post in our G&L Knowledgebase forum: Can you tell me which allen wrenches I need for my G&L?.

You might be missing the nylon bushing which goes between the screw and the trem bar.
See: G&L's DF Vibrato System.

Does your trem bar have a slotted end? If so, you might try using a blade screwdriver to spread the slot wider.

Hope this helps.

[Danley]

The nylon bushing seems to harden over time, making bar tightening more of an on/off engagement; new ones are available but unsure how they fit.