Bullet Truss Adjust

[Danley]

I dislike the adjustment being deep in a hole, for a few reasons: One is more difficult access (introducing the possibility of the hole being marred by the Allen wrench,) also the bare maple hole reminds me too much of a Squier (at least US Fender uses a walnut plug.) Will any bullet adjusters (aftermarket or old pre-BBE) fit direct with no modification?

[Craig]

I dislike the adjustment being deep in a hole, for a few reasons: One is more difficult access (introducing the possibility of the hole being marred by the Allen wrench,) also the bare maple hole reminds me too much of a Squier (at least US Fender uses a walnut plug.) Will any bullet adjusters (aftermarket or old pre-BBE) fit direct with no modification?

Have you tried a T-Handle Allen Wrench? Just make sure to use the correct size for your guitar, see: Can you tell me which allen wrenches I need for my G&L?

Hope this helps.