new guy
-
- Posts: 2
- Joined: Thu Dec 11, 2014 10:35 am
new guy
Ok, Hello all. Got my first G&L, a bluesboy tribute, not too bad, not as refined as the MIM Fender but. Sound is great, am use to early 90’s PRS guitars, so…I like this better than the MIM fender. Pickups, bridge, tuning machines, better, setup ok. After fret level, crown and polish, set up to G&L recommend specs (ok I tweaked a little bit) now plays as good as my USA guitars, didn’t have a nut blank thick enough and found the fender nuts too thin, so thats later. am going to upgrade switch and pots but I think i’m going to leave PU’s especially bridge, ordered a no load tone to see if can brighten neck hum, don’t want to do a 500k cause bridge is perfect and don’t wanna mess that up! Anyway,
-
- Site Admin
- Posts: 11349
- Joined: Tue Mar 03, 2009 10:52 am
- Location: Either Coto De Caza, CA or Paso Robles, CA
Re: new guy
Welcome!rickman30 wrote:Ok, Hello all. Got my first G&L, a bluesboy tribute, not too bad, not as refined as the MIM Fender but. Sound is great, am use to early 90’s PRS guitars, so…I like this better than the MIM fender. Pickups, bridge, tuning machines, better, setup ok. After fret level, crown and polish, set up to G&L recommend specs (ok I tweaked a little bit) now plays as good as my USA guitars, didn’t have a nut blank thick enough and found the fender nuts too thin, so thats later. am going to upgrade switch and pots but I think i’m going to leave PU’s especially bridge, ordered a no load tone to see if can brighten neck hum, don’t want to do a 500k cause bridge is perfect and don’t wanna mess that up! Anyway,
Please check out this post, as it will help you navigate our site and provide instructions on posting photos of
your Tribute Bluesboy: Welcome! Read This First.
See, we do require photo proof of it's existance.
--Craig [co-webmaster of guitarsbyleo.com, since Oct. 16, 2000]
Welcome! Read This First
Got a G&L question? Check out the: G&L Knowledgebase
Current G&L Specifications and Options
Welcome! Read This First
Got a G&L question? Check out the: G&L Knowledgebase
Current G&L Specifications and Options
-
- Posts: 2344
- Joined: Thu Feb 17, 2011 7:18 pm
- Location: None of the above
Re: new guy
Welcome to GbL!
Ken
Ken
-
- Posts: 631
- Joined: Thu Dec 09, 2010 11:15 am
- Location: British Columbia