any NAMM pictures yet ??
-
- Posts: 2153
- Joined: Fri Feb 15, 2013 12:11 pm
- Location: Dayton , Ohio
any NAMM pictures yet ??
anybody have any Namm pictures yet ??..... seen a few photo's but no G&L's
-
- Posts: 675
- Joined: Tue Jun 18, 2013 12:45 pm
Re: any NAMM pictures yet ??
I looked around at the usual suspect's websites and did not see anything from G&L.
Hopefully I am wrong but I don't know why a vendor would have a NAMM booth if they had nothing new to present but it does not seem to have caught the attention of anyone if they did.
I guess a presence could snag a few passers by but I don't think it would result in an article or other form of publicity without something new.
Hopefully I am wrong but I don't know why a vendor would have a NAMM booth if they had nothing new to present but it does not seem to have caught the attention of anyone if they did.
I guess a presence could snag a few passers by but I don't think it would result in an article or other form of publicity without something new.
-
- Posts: 787
- Joined: Fri Feb 26, 2010 3:12 pm
- Location: B.C.
Re: any NAMM pictures yet ??
Someone posted this to another forum
-
- Posts: 793
- Joined: Tue Mar 02, 2010 1:16 pm
- Location: Portland, Oregon
Re: any NAMM pictures yet ??
I think a couple of years ago, they didn't have a booth at all.
Bill
Bill
-
- Site Admin
- Posts: 11349
- Joined: Tue Mar 03, 2009 10:52 am
- Location: Either Coto De Caza, CA or Paso Robles, CA
Re: any NAMM pictures yet ??
As I mentioned in my Global Announcement posted on 1/21: Where's Craig 1/23-2/2 ..., I would be posting a NAMM report and photos.Fumble fingers wrote:anybody have any Namm pictures yet ??..... seen a few photo's but no G&L's
The last leg of my back to back to back trips was postponed so I will be posting the report earlier than expected. I will be doing it this afternoon.
--Craig [co-webmaster of guitarsbyleo.com, since Oct. 16, 2000]
Welcome! Read This First
Got a G&L question? Check out the: G&L Knowledgebase
Current G&L Specifications and Options
Welcome! Read This First
Got a G&L question? Check out the: G&L Knowledgebase
Current G&L Specifications and Options