whammy bar issue

ADYAPOOP · Post by **ADYAPOOP** » Mon Jun 10, 2013 4:23 pm

hi everyone,

the whammy bar is very , very loose in my legacy. if i tilt the guitar over a bit it falls right out, any suggestions? thanks

Fumble fingers · Post by **Fumble fingers** » Mon Jun 10, 2013 4:34 pm

put some tension on the bolt that holds it in

Lefty · Post by **Lefty** » Mon Jun 10, 2013 4:36 pm

There is a screw on the back side of the bridge that allows you to adjust the tension on the bar.

ADYAPOOP · Post by **ADYAPOOP** » Mon Jun 10, 2013 4:50 pm

thanks a lot!

Post by **Craig** » Mon Jun 10, 2013 5:27 pm

ADYAPOOP wrote:hi everyone,

the whammy bar is very , very loose in my legacy. if i tilt the guitar over a bit it falls right out, any suggestions? thanks

See Can you tell me which allen wrenches I need for my G&L?,
which is located in the Knowldegebase.

Hope this helps.

Guitars by Leo (aka "GbL")

whammy bar issue

whammy bar issue

Re: whammy bar issue

Re: whammy bar issue

Re: whammy bar issue

Re: whammy bar issue