Bending a DFV Arm

[Boogie Bill]

So...I have a DFV arm, that doesn't have very much curve in it. I need to bend it, but it's tougher than me.

I used to be able to bend steel with my bare hands, but after that Delilah girl cut my hair....well, I just haven't felt like my old self for a long time.

(If you know what I mean.)

Anyone know of any tricks on how to get this arm bent the way I want it?

Bill

(Or, if you have Uri Geller's phone number, have him call me!)

[louis cyfer]

wrap it in tape, put it in a vise to the point where you want to bend and pull. you might need to put a little extension (like a tube, or put it in the end a a drill) on that part to give better leverage,

[blargfromouterspace]

wrap it in tape, put it in a vise to the point where you want to bend and pull. you might need to put a little extension (like a tube, or put it in the end a a drill) on that part to give better leverage,

This works an absolute treat. I once used this method to bend a part of a tractor I damaged and ended up breaking the vice, which then landed on my foot Gotta love steel capped boots.

[louis cyfer]

wrap it in tape, put it in a vise to the point where you want to bend and pull. you might need to put a little extension (like a tube, or put it in the end a a drill) on that part to give better leverage,

This works an absolute treat. I once used this method to bend a part of a tractor I damaged and ended up breaking the vice, which then landed on my foot Gotta love steel capped boots.

the dfv arm will bend. maybe the tractor part was a little heavier duty.