Sat May 14, 2011 6:19 am
Question on the Broadcaster: Was the 1/4" jack originally mounted on a curved plate, mounted with 4 screws? Or was it always a thru the body mount? I have S/N: BC00509 which has it mounted on a plate, and I'm trying to find out if this is original or if the previous owner did this. The plate is painted wrinkle-finish black so I never questioned it before; but I'm selling it and the question has come up. Thanks!
Sat May 14, 2011 9:08 am
Hi Marc,
That part is non-original. Broadcasters have Switchcraft jacks but they are known
to go bad if you don't use a cable with a proper jack, i.e. metric versus imperial. They are usually replaced using these
instructions or replaced by a jack on a plate.
Hope this helps,
- Jos