Tue Jun 18, 2019 8:36 am
Tue Jun 18, 2019 8:45 am
Danley wrote:The nice thing about a bullet adjuster is even if it strips the Allen hole, you can notch it for easy removal or continue to use it. I’m still pretty particular about truss adjusters not being worn though - Mine isn’t too very worn but I like to replace them with fresh ones when available.
The early/plastic sleeve pre-bicut adjusters are smaller than the later ones available in G&L’s online selection - Fender bullets are greater diameter than old G&L as well. Does anyone have tabs on a replacement bullet that is easily available? Or would it be the machine shop route to grind a later one down?
Tue Jun 18, 2019 10:14 am
Tue Jun 18, 2019 10:32 am
Danley wrote:That’s the one I mentioned in my post - it looks like that’s a later bi-cut bullet like my SC3 ; good they’re available but would be too big to fit.
Replacement Truss Rod "Bullet" for USA instruments manufactured from 80's - 06'. Included are two brass spacer washers. We recommend professional installation only. Current US models have dual-action truss rod with integrated bullet that is welded on, not replaceable.
Uses 1/8" hex wrench (not included).
Replacement 4mm Truss Rod Nut for Tribute Series models and USA instruments manufactured from mid-2006 to mid-2013. Includes two brass spacer washers. Current US models and Tributes built 2015 and later have dual-action truss rods with integrated truss nut that is welded on, not replaceable.
Includes adjustment 4mm hex wrench.
Tue Jun 18, 2019 11:20 am
Fri Jun 21, 2019 1:27 pm
Fri Jun 21, 2019 2:27 pm
derick wrote:The pre-bicut truss rod bullets are different than the ones sold at the G&L website. I was able to source one by calling musicman directly.
Thu Aug 08, 2019 4:55 pm
Sat May 22, 2021 8:32 am