Today, I received a 2013 USA G&L Legacy, which I purchased on eBay in "like new" condition from an individual seller (who purchased it from a G&L dealer).
The neck was slightly bowed, so I tried using the included (original) 4mm wrench to adjust the truss rod. However, I wasn't able to insert the allen wrench into the truss rod nut, as the truss rod nut isn't aligned perfectly with the access hole in the headstock. To adjust the truss rod, I have to insert the allen wrench at an angle; I'm able to add/remove relief to a limited extent, but don't feel comfortable doing this, as I do not want to risk stripping the nut.
Truss Rod Nut:
http://i.imgur.com/rCcMH2m.jpghttp://i.imgur.com/kqOzDtm.jpgThis is as far as the allen wrench can go.
http://i.imgur.com/AJs6F6N.jpgI wasn't sure if this was an anomaly on my particular guitar, or if it was common to all recent Legacy guitars. This is an example of one (of many) brand new G&Ls sold on eBay:
http://i.imgur.com/C6gZvlr.jpgThe truss rod nut on my Legacy, which seems similar in comparison:
http://i.imgur.com/4p15BHM.jpgIs the truss rod nut position similar on other recent G&Ls, or should I look into sending this back? If there is nothing wrong with the truss rod/nut, any suggestions on how the truss rod should be adjusted? Thank you.