Thu May 03, 2012 5:35 am
Hi, and thanks again Craig for the current factory settings site. I set the vibrato to the specs given 2/16 clearance and the DFS works a lot better.
The older G&L manual on line said to hold down E6th at the 1st and 22nd fret and to set the clearance at the 8th fret between .010 and .012 from the top of the fret to the bottom of the string, is this still the same for the new G&Ls?
I also lowered the bridge plate a tad because the 1st and 6th bridge was bottomed out.
The string clearances are pretty well set to factory specs but I wish I could get better, I'm getting a slight string buzz, I guess I'm too fussy.
Thanks so much
Rodger